Toshiba RAS-10SKVP-ND Mode D'emploi page 27

A1YPGTU/CPWCNA'0HO 2CIG  9GFPGUFC[ ,CPWCT[     2/
4
Wash and then dry.
(1) Soak in hot water at 40 to 50°C for about 10 to 15 minutes. If the staining is particularly
severe, use a washing detergent compound (weak basic or neutral) at 10 to 15 times
the standard concentration.
(2) Rub up and down, and rub left and right. Also, rub the surface gently with a sponge.
(3) Rinse with running water.
(4) Shake thoroughly, and allow the unit to drain.
(If oil or smoke strains are particularly hard to remove, repeat steps (1) to (4) 2 or 3
times.)
(5) Dry thoroughly in the shade.
CAUTION
• Never use any products marked as "bleach".
• Do not attempt to disassemble the unit.
• Do not rub with a scrubbing brush or similar implement.
• Do not utilize washing devices or equipment.
• Do not dry with a hair dryer or other appliance that uses hot air. (The heat can cause the unit
to deform.)
• After cleaning, wait until the unit is completely dried before attaching. The FILTER indicator
may turn on if the unit is used while wet.
5
Attach the plasma pure filter.
• Grasp the handles, and then insert as shown in a. Insert into the right and left guide rails,
and then press in the direction of b after it is all the way in.
• Press both ends of the plasma pure filter in the direction of c until the protrusions on both
sides of the plasma pure filter are completely inserted into the holders.
Press in the plasma pure filter until the protrusions on both sides are completely inserted
into the holders. If installation is incomplete, the FILTER indicator (orange) may light.
6
Attach the air filter, and then close the air inlet grille.
23
3
2
1
Holder
Protrusion
Plasma pure filter
EN