Fire-Fighting Safety Measures; First-Aid Measures; Beam Protections; Technical Description - Nordica 50 Mode D'emploi

FIRE-FIGHTING SAFETY MEASURES

When installing the appliance, the following safety measures must be observed:
a) In order to ensure sufficient thermal insulation, respect the minimum safety distance from objects or furnishing components
flammable and sensitive to heat and from materials with flammable structure (see CE MARKING INFORMATION -
All the minimum safety distances are shown on the product data plate and lower values must not be used.
b) in front of the furnace door, in the radiation area, there must be no flammable or heat-sensitive objects or material at a distance
of less than 80 cm. This distance can be reduced to 40 cm where a rear-ventilated, heat-resistant protection device is installed
in front of the whole component to protect;
If the product is installed on a no totally refractory floor, one must foresee a fireproof background. The floors made of
c)
inflammable material, such as moquette, parquet or cork etc., must be covered by a layer of no-inflammable material (size
according to regional law, see
The ash drawer must always be inserted when the appliance is in operation.
The solid combustion residues (ashes) must be collected in a metal container that is hermetically sealed and fire resistant. The
appliance must never be lit in the presence of gaseous emissions or vapours (for example: glue for linoleum, petrol, etc,). Do not
place flammable materials in the vicinity of the appliance.
During the combustion, thermal air is emitted by involving the heating of areas, door and glass hearth, of the door handles
or controls, of the smokes pipe and, in case, of the front part of appliance. Avoid to touch those parts without a protective
clothing or without accessory tools (gloves resistant to heat, control devices). Ensure children are aware of these
dangers and keep them away from the furnace when it is on.Warn children that the device becomes very hot and
that it must not be touched.
When using the wrong fuel or one which is too damp, due to deposits present in the flue, a flue fire is possible.

FIRST-AID MEASURES

Should any fire arise in the stack or in the flue:
a) Close the feeding door.
b) Close the registers of combustion air
c) Extinguish the fire using carbon dioxide fire-fighting means (CO
d) Seek immediate intervention of FIRE BRIGADE.
DO NOT ExTINGUISH FIRE USING WATER JETS. When the flue does not burn any more please arrange an examination by a
specialist in order to find possible cracks and permeable points.

BEAM PROTECTIONS

Considering the irradiation of the hearth, it is necessary to be particularly careful in protecting the beams while designing your stack.
Consider the proximity of beams to the external surfaces of the hearth, on one side, and the irradiation of the glass door, usually very
close to the beams, on the other side. In any case, it has to be considered that the internal or lower surfaces of this beam in flammable
material must not come in contact with temperatures higher than 65 °C.
WARNING: We cannot be made liable for a wrong operation of the plant, when it does not comply with the provisions
of these instructions or when it uses additional products not suitable for this device.

TECHNICAL DESCRIPTION

The appliance is made up of a steel chamber completely soldered and hermetic. The hearth is coated by single cast-iron sheets
and refractory plates (NORDIKER).
made up of a galvanized steel carter external to the heating body. Inside the hearth there are a grate holder and the
related grating, both made of very thick cast-iron and easily extractable.
appliance.
The insert is equipped with a sight door with ceramic glass (resistant up to 700°C). This allows a charming sight on burning flames.
Moreover, in this way, any possible leak of sparks and smoke is avoided. Under the hearth grating there is a easily extractable ash
drawer, also when the appliance works.
ACCESSORIES
INSERTO 50 Crystal
INSERTO 50V Crystal BII
INSERTO 50V p30 Crystal
INSERTO 70 Crystal
INSERTO 80 Crystal EVO
INSERTO 100 Crystal
The heating of the room occurs:
22
Picture 1).
The appliances are equipped with an integrated air circuit for the recovery of the heat
POKER GLOVE
SERIES SERIES
SERIES SERIES
SERIES SERIES
SERIES SERIES
SERIES SERIES
SERIES SERIES
ENgLIsH
dust).
2
Picture 2 gives some examples of execution.
The appliance works as an intermittent operating
Ventilation KIT 1318000
/
/
/
OPTIONAL
OPTIONAL
OPTIONAL
Picture
SECONDARY air KIT
6016040 OPTIONAL
6016040 OPTIONAL
6016040 SERIES
6016041 OPTIONAL
6016041 OPTIONAL
6016041 OPTIONAL
7).