Control Panel - HQ Power HQLE10026 Mode D'emploi

4.3 Connection

Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. All devices must be powered
directly off a grounded switched circuit. Do not connect to a dimmer pack.

The installation has to be approved by an expert before the device is taken into service.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 bracket
2 microphone
3 display + menu buttons
6. Operation
The device can be used in the following modes:

stand-alone mode

master/slave

with a DMX-512 controller.
6.1

Control Panel

Access the control panel functions using the four panel buttons located around the display.
Menu scroll through the menu options
upwards through the menu list
downwards through the menu list
Enter confirm a selection
6.2 Menu
mode
auto
sound
speed
sensitivity
silent scene
InFr
Addr
Slave
Display
V. 01 – 22/06/2017
HQLE10026
programme description
Au-1 auto programme 1
Au-2 auto programme 2
... ...
Au-6 auto programme 6
Au-7 auto programme 7
So-1 sound programme 1
So-2 sound programme 2
... ...
So-6 sound programme 6
So-7 sound programme 7
SP1-SP9 adjustable speed value
Se1-Se9 adjustable sensitivity value
on activated with ambient noise in sound mode
off de-activated with ambient noise in sound mode
on IR remote mode activated
off IR remote mode de-activated
4CH 4-channel DMX mode
Slav slave mode
dISP normal display mode
dSIP inversed display mode
4 safety eye
5 power input
6 DMX input and output
6 ©Velleman nv