Velleman HAA9523S Mode D'emploi page 18

• Use the N.O. output contact to shunt a N.C. protection zone of an alarm system.
• Set the output contact to start / stop mode (programming option 51).
2. Alarm system arm-disarm control (white/brown and blue or purple wires) (fig. 11)
• Use the N.O. or the N.C. output contact to set the alarm system in arm-disarm mode.
• Refer to the manual of your alarm control panel for the appropriate output contact to be used in arm-
disarm control.
• Usually set output 2 to momentary mode (programming option 501) for multi-station systems and
start / stop mode (programming option 51) in single-station systems.
(F) Output 3 (white/red wire) (fig. 12)
Output 3 is an open collector output prepared for auxiliary controls. It
may be used for arm-disarm of a security system, enabling and
disabling of a keypad or a protection zone, etc. It can also drive a relay
to give full function of N.C. and N.O. outputs.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
v2 15/11/2013
HAA9523S
18 VELLEMAN