Operating Modes - Danby DAS090BAHWDB Manuel D'utilisation

OPERATING INSTRUCTIONS

OPERATING MODES

AUTO mode
• Press the MODE button to select AUTO mode.
• The appliance will automatically select cooling,
or fan only operation depending on what
temperature has been set and the ambient room
temperature.
DRY (dehumidifying) mode
• Press the MODE button to select the DRY mode.
• The fan speed cannot be adjusted in this mode.
The fan operates at LOW speed.
• Keep windows and doors closed for the best
dehumidifying effect.
• Condensed water will automatically drain
through the drain hose.
Note: The fan speed cannot be adjusted in AUTO
and DRY mode.
COOL mode / HEAT mode / FAN operation
• Press the MODE button to select the desired
mode; COOL, HEAT or FAN.
• Press the UP or DOWN buttons to select your
desired room temperature. The temperature can
be set within a range of 17°C - 30°C (62°F -
86°F).
• Press the FAN button to choose the fan speed:
Auto, Low, Med or High.
SHORTCUT function (only available on remote):
• Used to save a favourite setting
• Set the unit to the temperature and fan speed that
you would like to set as a favourite
• Press and hold the SHORTCUT button for 2
seconds
• Press the SHORTCUT button at any point in future
to return to the favourite setting
• If no favourite is set, pressing the SHORTCUT
button will cause the unit to run in AUTO mode at
26°C (79°F), with fan speed set to AUTO
Anti-Cold Air Feature
• The fan speed and the louver angle adjust
according to the ambient temperature. The
manual control button and remote control cannot
adjust fan speed or louver angle in this setting.
SLEEP function
• The SLEEP function is used to decrease energy
use during sleeping hours. This function can only
be activated by pressing the SLEEP button on the
remote control.
• When in COOL mode, the temperature will
increase by 1°C (2°F) in the fi rst hour and will
increase an additional 1°C (2°F) in the second
hour. The appliance will then hold this new
temperature for 5 hours. At the end of the SLEEP
cycle, the appliance will turn off.
• When in HEAT mode, the temperature will
decrease by 1°C (2°F) in the fi rst hour and will
decrease an additional 1°C (2°F) in the second
hour. The appliance will then hold this new
temperature for 5 hours. At the end of the SLEEP
cycle, the appliance will turn off.
Note: The sleep feature is not available in FAN and
DRY mode.
AUTOMATIC FEATURES
Auto-Restart
If the appliance loses power, it will automatically
restart with the previous settings once power is
restored.
Louver Angle Memory
When turning on the appliance, the louver will
automatically resume the previous angle setting.
Refrigerant Leakage Detection
The indoor appliance will automatically display
"EC" when it detects a refrigerant leakage and the
appliance will shut off.
5