Maytag MHW7000XW Guide D'utilisation Et D'entretien page 11

8.
Select CYCLE
heavy duty
whites
small
load
rinse/drain
& spin
soak
Steam model shown
Turn cycle knob to select your wash cycle. See "Cycle Guide"
for details on cycle features. Not all options and settings are
available on all cycles.
9.
Adjust settings, if desired
+
-
temp level soil level
Steam model shown
The display will show the default settings for the selected
cycle. If desired, press the button beneath each setting to
adjust the Temp Level, Soil Level, and Spin Speed. Adjusting
the Soil Level will change the Estimated Time Remaining.
Overloading, unbalanced loads, or excessive suds may also
cause the washer to increase the cycle time.
NOTE: Not all settings are available on all cycles. See "Cycle
Guide" for available settings.
10.
Select any additional options
Steam model shown
To add additional options to the cycle, such as Extra Rinse,
Fresh Hold, Stain Clean/Steam for Stains (on some models), or
Max Extract (on some models), press the button for the desired
options to add them to the selected cycle.
NOTE: Not all options are available with all cycles. See "Cycle
Guide" for available options.
normal
wrinkle control
bedding
allergen
delicate
clean
washer
with
spin speed
11.
Setting a delayed start
+
-
If you do not want to begin a cycle immediately, you may
choose the DELAY START option. This will delay the start
of the wash cycle by up to 10 hours on models with Steam,
and 8 hours on non-Steam models.
To set a delayed Start:
1. Press DELAY START s and t buttons to set the desired
delay time.
2. Press START/PAUSE to set the delay. The delay countdown
has started when the START/PAUSE light stops blinking.
12.
Press and hold START/PAUSE
to begin wash cycle
Press and hold the START/PAUSE button to start the wash
cycle. To pause a cycle in progress, press the START/PAUSE
button once, then press and hold again to continue the cycle.
To cancel a cycle, press the POWER/CANCEL button.
Once you press and hold START/PAUSE, you will hear the
door lock, unlock, and lock again. The washer door will remain
locked during the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2 missed garments,
you may do so while the "Add a Garment" light is lit.
Press START/PAUSE once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Then close
door and press START/PAUSE again to restart
the cycle.
temp level soil level
11