Sony VPL-FX200U Mode D'emploi page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Notes on setting of the index number
• Set the same group index number for all
equipment of the same system connection (those
on the signal route between the signal source and
the projector).
PC-3000
PJ COM
Signal flow
PC-3000
Signal flow
PJ COM
Projector
PC-3000
PJ COM
Signal flow
Projector
Signal flow
PJ COM
Projector
For setting the group index number, see "GROUP INDEX"
on page 31 (GB).
• Set the correct group and device index numbers
and the switcher number.
Do not set the same device index number or the same
switcher number in one group.
For example, if there are different pieces of
equipment with the switcher number 1, the error
message will appear when the SYS SET key is
pressed.
• Set the switcher that outputs the signal to the
projector to number 1.
PC-3000
PC-3000
Projector
Set the same group
index number.
Set the different
group index number
for two systems.
Set the same group
index number.
Set this switcher to 1.
Notes on connections when two or more
switchers are used
• Mount the IFB-12A interface board to the slot 1 of
the number n switcher and connect the output
connector of the number (n+1) switcher to the
IFB-12A.
• You can attach the IFB-12A signal interface board
(when the IN/OUT switch is set to OUT) only to
the number 1 switcher.
37
(GB)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vpl-fx200eVpl-fx200m

Table des Matières