Connecting With A Computer Or A Vcr - Sony VPL-FX200U Mode D'emploi

Connecting with a Computer or a VCR

SMF-400 Monitor cable
(5BNC˜HD D-sub 15-pin)
(not supplied)
Use the optional ADP-20
Signal adapter (not supplied)
when connecting with a
Macintosh computer.
20
(GB)
This section describes how to connect the projector with a computer, VCR,
and external active speakers.
For details on how to connect other equipment, see pages 33 (GB) to 35 (GB).
Also refer to the instruction manuals of the equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out by
the plug, not the cable itself.
Note on the VPL-FX200E model
The optional IFB-X2000E interface board is required for using the VIDEO
connectors.
VCR
to
to S VIDEO OUT
VIDEO
OUT
S video cable
(not supplied)
Rear
INPUT C INPUT B
INPUT A VIDEO
AUDIO OUT
REMOTE CONTROL S TRIG DEVICE INDEX
0
Audio cable
(not supplied)
Audio cable
(not supplied)
Computer
Note
Set INPUT-A in the SIGNAL SELECT menu to RGB.
For details, see page 32 (GB).
to AUDIO OUT
Video cable (not supplied)
Audio cable
(not supplied)
+
–
to AC IN
Active speakers
to a wall outlet
AC power cord
(supplied)
Signal flow
: