Reversing The Door - AVG BSC46DB2 Manuel D'utilisation

REVERSING THE DOOR

IMPORTANT: THIS OPERATION REQUIRES AT LEAST TWO (2) PERSONS.
11
INSTRUCTIONS
1. Open the door at a 90ᵒ angle, take out two screws from lower door axis (#3) and pull out door.
2. Set the door aside in a safe place and take out decorative nail (#7) from top of door frame.
Remove the two screws (#4) at bottom and take out the Extrusion‐board of lamp switch (#5).
Install the Extrusion‐board of lamp switch (#5) at top of door frame and use spare decorative
nails to block the hole at top of door frame.
3. Unscrew the three screws (#8) from top right hinge (#6) and take out the right top hinge.
4. Remove the decorative nails (#10) from left top of cabinet and install the spare top hinge (#9)
at left top of cabinet using the three screws.
5. Install spare lower hinge (#11) onto left lower cabinet.
6. Rotate the door 180ᵒ then re‐install it in the same way it was removed, making sure it is
aligned properly.
7. Block the hole at right top of cabinet with the spare decorative nail.
28