ergoline Ambition 200 VHP 15 Instructions D'utilisation page 50

Presets
The reading is immediately displayed.
– Press to go to Parameter 19 (P19).
P19 – Total Hour Accumulator
The total hour accumulator displays the total numbers hours on the unit
since first day of operation. The accumulator counts from 0000 to 9999
then rolls over. The total hour accumulator cannot be adjusted or reset.
The reading is immediately displayed.
– Press to go to Parameter 24 (P24).
P24 – Continuous Countdown Mode
The continuous countdown mode allows the studio operator to maintain
a tighter schedule by disabling the pause function of the timer thus al-
lowing the tannig time to continue to count down even if the lamps are
turned off by pressing Stop key.
When parameter 24 is shown, the display will read 0000 continuous
countdown mode off.
– Press to go to P25 without changing the setting.
To enable continuous countdown mode:
– Press Reset once and then release it. The display will begin to flash.
– Press unitl 0001 is displayed.
– Press Reset once then release it.
The continuous countdown mode is now enabled. To disable this
function change parameter 24 back to 0000.
50
– Press to go to Parameter 25 (P25).
P25 – Keylock Configuration
The keylock configuration option allows the studio operator to maintain a
higher sense of security by locking out the front rail keys in several spe-
cified intervals while the timer is connected to a network.
The keylock intervals are:
0 – Lock keys and release only when power cycled.
1 – Lock keys and release only when parameter is changed to an option
other than 01.
2 – Lock keys and release only after the network cable has been remo-
ved for 2 minutes.
3 – Lock keys and release only after the network cable has been remo-
ved for 30 seconds.
CAUTION!
Do not set parameter 25 to 01 unless you have a CCS-
IV or other control device!
You will be unable to change this parameter or unlock the
front rail keys without the use of CCS-IV or other control de-
vice. The Intellitan Protocol Interface (IPI) does not edit this
or any other parameter.
When parameter 25 is shown, the display will read 0003 for 30 seconds.
– Press to go to P26 without changing the setting.