Standard Settings - ergoline Ambition 200 VHP 15 Instructions D'utilisation

Presets

Standard settings

P ...
P01 – password
P02 – alarm
P03 – fan delay
P04 – session delay
P05 – station address
P06 – lamp hours
P07 – A/C voltage phase A
P08 – A/C voltage phase B
P09 – average voltage phase A
P10 – average voltage phase B
P11 – internal operating temperature
P12 – ambient or room temperature
P13 – average operating temperature Read only (no setting possible)
P14 – average ambient or room temp. Read only (no setting possible)
P15 – Clean Room Feature
P16 – Econometer
P17 – session cost per minute
P18 – session counter
Setting
Level 1: 0010 Level 2: 0102
Enabled
1 minute
No session delay
0000
0000
Read only (no setting possible)
Read only (no setting possible)
Read only (no setting possible)
Read only (no setting possible)
Read only (no setting possible)
Read only (no setting possible)
Disabled
Read only (no setting possible)
Unit KwH Draw x National Average /
60 minutes
Read only (no setting possible)
P19 – total hour accumulator
P20-23
P24 – continous countdown mode
P25 – keylock configuration
P26 – TPI mode toggle
P27 – Timer Protocol Option
P28 – Total Operating Cost Accumu-
lator
P30 – facial control
P32 – facial lamp hour accumulator
P01 – Enter Password Clearance
– Press and at the same time (button „Time") and hold in for
one (1) second, then release. The display will change from 00:00 to
0000.
– Press Reset once and release.
The four (4) zeros (0000) will now flash.
– Press and hold down until the timer display scrolls up to 0010
(for level 1 or view password) or 0102 (for level 2 or edit password),
then release key.
– Now press Reset once again.
The display will stop flashing and read 0001 if level 1 was selected or
0002 if level 2 was selected.
Read only (no setting possible)
Reserved for factory use
Disabled
0003
Disabled
0000 = Intellitan Protocol
0000 (readable and resettable)
not used
not used
45