ergoline Ambition 200 VHP 15 Instructions D'utilisation page 49

Presets
– Press to go to Parameter 15 (P15).
P15 – Clean Room Feature
When on, the clean room feature will show all dashes (----) on the timer
display at the end of each tanning session to show that the tanning unit
needs to be cleaned. In network mode, no new time can be placed on the
timer when the clean room indicator is displayed. To reset the clean room
feature from the room, indicating that the room has been cleaned, press
the Reset button twice in rapid succession.
When parameter 15 is shown, the display will read 0000 for clean room
feature off.
– Press to go to P16 without changing the setting.
To enable the clean room feature:
– Press Reset once and then release it. The display will begin to flash.
– Press once to display 0001.
– Press Reset once then release it.
The clean room feature is now enabled.
To disable the clean room feature change parameter 15 back to
0000.
– Press to go to Parameter 16 (P16).
P16 – Econometer
The econometer measures the electrical cost to power units for the pre-
vious session or the current session if the unit is energized. The cost is
derived from the session cost per minute entered in P17.
The reading is immediately displayed. Measurement is in cents and
tenths of a cent.
– Press to go to Parameter 17 (P17).
P17 – Cost per Minute
This figure is automatically entered into the tanning unit's data bank in
accordance with the National Average of 7.5 cents per kilowatt hour. The
formula used is Unit kwH Draw x National Average / 60 minutes = cost
per minute.
– Press to go to P18 without changing the setting.
To change the cost per minute:
– Press Reset once and then release it. The display will begin to flash.
– Press or to reach the desired setting.
Measurement in cents and tenths of a cent. For example: A reading
of .4 would equal four tenths of one cent.
– Press Reset once then release it.
The cost per minute is now set.
– Press to go to Parameter 18 (P18).
P18 – Session Counter
The session counter displays the total number of times a session has
been started since first day of operation. The session counter counts
from 0000 to 9999 then rolls over. The session counter cannot be adjus-
ted or reset.
49