Metabo HPT CJ 18DA Instructions De Sécurité Et Mode D'emploi page 20

English
6. Angular cutting
The base can be swiveled to both sides by up to 45°
for angular cutting. (Fig. 27)
Base
45°
45°
(1) Loosen the base bolt by hexagonal bar wrench
attached on base and move the base fully forward.
(Fig. 21)
(2) Align the scale (from 0 degrees to 45 degrees by
15-degree increments) of the semi-circular part
of the base with the [ ] mark on the gear cover.
(Fig. 28)
Scale
(3) Tighten the base bolt again. (Fig. 21)
(4) Set the orbital position to "0" - "ІІІ".
NOTE
Angular cutting can not be done when adopting dust
collector.
20
mark
45
Semi-
circular
part
Scale
45
Fig. 27
mark
Semi-circular part
Fig. 28
CONCERNING CUTTING OF STAINLESS
STEEL PLATES
When used with the No. 97 blade (sold separately), can
cut stainless steel plates.
Note the following to adjus the unit.
CAUTION
● In order to prevent blade dislodging, damage
or excessive wear on the plunger, please make
sure to have surface of the base plate attached
to the work piece while sawing.
● Do not operate power tools in explosive
atmospheres, such as in the presence of
fl ammable liquids, gases or dust.
Jig saw create sparks which may ignite the dust
or fumes.
When cutting stainless steel plates, adjust the unit as
described below:
1. Adjust the speed
Blade
No. 97 1/16" – 5/32" (1.5 mm – 2.5 mm)
NOTE
The higher the speed is, the quicker the material is
cut. But the service life of the blade will be reduced in
this case. When the speed is too low, cutting will take
longer, although the service life will be prolonged.
Make adjustments as desired.
2. Set the orbital position to "0"
NOTE
When cutting use cutting fl uid (oil base cutting fl uid)
to prolong the blade's service life.
Oiler
Thickness of material
Change knob
Fig. 29