Stadler Form Simon Mode D'emploi page 8

9. The remote control (12) is magnetically attached to the pole (2) of the
device. It operates via radio. The battery compartment is on the back
of the remote control (12). Press the cover down to open the battery
compartment (2 x type AAA batteries).
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (4) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
• For external cleaning, rub with a damp cloth and then dry thoroughly.
• Make sure that the air inlet (13) and air outlet (14) are cleaned regularly to
prevent the build-up of dust. The air inlet (13) can be cleaned with a dry
brush or a vacuum cleaner.
• The air outlet grille (14) can be removed, making the fan blade (15) easy
to clean. Before doing so, make sure that the device is disconnected from
the mains. First of all, remove the screw (16) underneath on the housing.
Then turn the air outlet grille (14) anti-clockwise and remove it. Turn the
knob underneath (17) clockwise and remove it. The fan blade (15) can now
be taken out of the housing. Clean the fan blade (15) with a damp cloth and
a drop of detergent and then dry it thoroughly. Then clean the air outlet
grille (14) and dry it carefully.
• The textile cover (18) can be taken off the housing after all four screws
(19) have been removed. There are small holes in the textile cover which
are fitted over the front and back of the housing (20). The textile cover
(18) can be washed at 30° Celsius «(cold wash)» on a gentle cycle. Make
sure that the textile cover (18) is completely dry before attaching it to the
device again. When fitting the textile cover (18), make sure that the hole
in the cover for the pole (21) is in the right place. Now fit the textile cover
(18) over the device again by making sure that all the holes (20) line up
properly on the front and back of the housing. This will enable the cover
plate for the textile cover (22) to be put back correctly on the device. Then
push the fan blade (15) back onto the shaft (23) inside the housing first
of all and then turn the knob (17) anti-clockwise to tighten it. Attach the
air outlet grille (14) by turning it clockwise and tighten all 5 screws (16 &
19) again. It is imperative for the textile cover (18) to be fitted in order for
Simon to perform as described.
• Make sure that the air inlet grille (13), the air outlet grille (14) and the fan
blade (15) are completely dry and that all the screws (16 & 19) on the hous-
ing are firmly tightened before using the device again.
Repairs
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• Never operate the appliance if the adaptor or plug is damaged, after it has
malfunctioned, if it has been dropped or has been damaged in any other
way (cracks/breaks in the casing).
• Do not push any object into the appliance.
• If the appliance is beyond repair, make it unusable immediately by cutting
through the cable and hand it in at the collection point provided for the
purpose.