Stadler Form Simon Mode D'emploi page 7

screws at the back on the air inlet grille are firmly tightened. Do not plug the
mains cable into the socket until you have finished assembling the device.
Remove the fixing screw (1) from underneath the pole (2).
•
Insert the pole (2) into the foot (3) and secure it using the screw (1).
•
Finally, push the fan housing onto the top of the pole (2) until you hear
•
the pole click into place.
Note: When the device is used for the first time, the motor will have to align
itself first. This can take a couple of seconds.
Setting up / operation
1. Place Simon in the desired location on a flat surface. Connect the cable
for the power adapter (4) to the cable for the foot-operated switch (5).
Connect the power adapter to a socket with the correct voltage rating.
2. Switch on the appliance by pressing the on/off button (5) on the foot-
operated switch (5). The appliance gives an audible signal
3. Press the button for the selection of the speed level (7) to change the
fan speed (levels 1–10). Pressing once increases the speed by one level.
If you would like to increase the speed by another level, press again.
The setting chosen is indicated by the number of LEDs illuminated un-
derneath the on/off button (6) (1 LED for levels 1 + 2, 2 LEDs for levels 3
+ 4, 3 LEDs for levels 5 + 6, 4 LEDs for levels 7 + 8 and 5 LEDs for levels
9 + 10).
4. Activate swing mode by pressing the vertical swing mode button (8).
The appliance now swings at an angle of approx. -5°–85° to ensure
optimum distribution of cooling air throughout the room. Press the swing
mode button (8) again if the appliance is to remain at a certain angle.
5. For optimum distribution of cooling air from left to right, activate the
horizontal swing function (9). Together with the vertical swing function,
this will create 3D air circulation throughout the whole room. There are
3 angle settings to choose from for the horizontal swing function: 60°,
90° or 180°. To select a setting, press the button for the horizontal swing
function (9) until the LED underneath your chosen angle setting lights
up. If the LED underneath the button (9) is not illuminated, the horizontal
swing function is deactivated.
6. Press the button for the selection of "Natural Breeze" mode (10) for
natural wind conditions. The white LED above the button (10) will now
light up. This mode provides an even more pleasant cooling effect, simu-
lating a natural breeze. The fan speed of this breeze automatically varies
depending on the selected speed level.
7. By pressing the button for the timer (11) you can set the operating time
for between 1 and 7 hours (for example, 3 h = 1 h and 2 h LEDs lit, 7 h =
1 h, 2 h and 4 h LEDs lit). The selected time is displayed above the timer
button (11) with white LEDs. Press once to set the operating time to 1 h,
press the button again for 2 h, and so on. The remaining time is indicated
by the illuminated LEDs above the timer button (11). The unit switches
off automatically after the set operating time has elapsed. If no LEDs are
lit above the timer button (11), the unit is set to continuous operation.
8. Switch off the appliance by pressing the on/off button (6). Alternatively,
you can switch off the device by pressing the foot-operated switch (5).
The device has a power memory function which stores the last setting
selected.