Maintenance; Warranty; Specifications - SEFRAM 63 Mode D'emploi

SEFRAM 63
Do not expose the instrument to direct sun light, high tempera-
ture and humidity or dewfall.
Remove batteries when the instrument will not be in use for a
long period.
9
• Unauthorized persons shall not disassemble the tester and the
supplementary equipment
When using testers in compliance with the instruction manu al,
•
no particular maintenance is required
• If functional errors occur during normal operating, our service
department will check your instrument without delay
10
The Instrument is subject to strict quality control. However, should the
instrument function improperly during normal use, you are protected
by our two years warranty.
We will repair or replace free of charge any defects in workmanship
material, provided the instrument is returned unopened and
unhampered with.
Damage due to dropping or incorrect handling is not covered by the

warranty.

If the instrument shows failure following expiry of warranty, our
service department can offer you a quick and economical repair.
11
Voltage range
LED nominal voltage
LED-tolerances
ELV-indication LED
Response time
Safety current
Peak current
Measurement duty
Internal battery consumption
Single-pole phase test voltage range
Phase rotation test
Continuity test
Battery
Temperature
Humidity
Altitude
Overvoltage
Standard
Protection

Maintenance

Warranty

Specifications

16
6...690 VAC/DC (16...800 Hz)
6/12/24/50/120/230/400/690 V
EN 61243-3
>50 VAC, >120 VDC
<1 at 100 % of each nominal value
Is < 3.5 mA (at 690 V)
<3.5 mA (at 690 V)
30 s ON (preparation time),
240 s OF (recovery time)
Approx. 80 mA
100...690 VAC (50/60 Hz )
170...690 V phase-to-phase,
AC (40-70 Hz)
0...500 kΩ + 50 %
3 V (IEC LR03 1.5 V x 2)
-15 °C...55 °C operation;
-20 °C...70 °C storage;
No condensation
Max 85% RH
up to 2000 m
CAT IV/600 V / CAT III/690 V
EN/IEC 61243-3:2014
IP 64
www.sefram.fr