Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Temperature setting
Temperature control:
P
Temperature regulation:
Temperature up:
Temperature down:
Error codes on the display
F1
If code F1 is displayed it means that the cabinet temperature sensor is defective
and service assistance should be requested. In the meantime the cabinet itself
will maintain the set temperature by the memory of the controller.
F2
If the display alternates between temperature and error code F2 there are
problems with the temperature sensor on the evaporator. This has no effect on
the operation of the cabinet, but the sensor should be replaced as soon as
possible. Request service assistance.
F3
If the display alternates between temperature and error code F3 there are
problems with the temperature sensor on the condenser. This has no effect on
the operation of the cabinet, but the sensor should be replaced as soon as
possible. Request service assistance.
NOTE! Applies only to cabinets with built-in compressor.
. . .
If the dots in the display flash, it indicates that the condenser temperature is too
high. Switch off the cabinet at the mains and see whether the condenser has
been covered. If this is not the case, the high temperature might be the result of
dirt on the condenser. The condenser can be cleaned with a brush or vacuum
cleaner. Switch on the cabinet again. After an hour, the cabinet should run
normally. If the dots begins flashing again, request service assistance.
NOTE! Applies only to cabinets with built-in compressor.
765041114
Press to see the cabinet temperature setting; the display will show
the set temperature.
P
Keep
pressed. At the same time, press
+
Each time
is pressed the temperature will change one degree.
When the display shows the desired temperature let go of the two
keys and the setting has been made.
P
Keep
pressed. At the same time, press
-
Each time
is pressed the temperature will change one degree.
When the display shows the desired temperature let go of the two
keys and the setting has been made.
+
.
-
.
17
Publicité
Table des Matières
