Oscartielle ANDROMEDA 2 Mode D'emploi page 23

8 - Loading and use of the unit (start-up)
If the display unit has been tipped during positioning and installation, wait at least three hours before starting it up in order
to give the lubricating oil enough time to collect in the compressor! The refrigerating unit may be irretrievably damaged if
this precaution is ignored.
The display unit can only be started up for the very first time after complying with points 3 and 4 above.
With the unit unplugged, remove the plastic film protecting the insides and outside and then clean (follow the instructions
in point 11 below).
Fit the various shelf supports at the height required, as shown in FIG. 11. FIG. 1 shows the best distances between
shelves.
Plug in the unit (having followed the instructions in point 6) and flip the switch fitted upstream (if any). A slight humming of
the motor and the lighting-up of the display indicate that the unit is powered up.
Switch on the lights using the switch on the decorative front panel (see FIG. 10).
The cabinet is equipped with a display located on the front decorative canopy FIG. 10
The electronic control instruction handbook for the displays is attached to the instruction manual. A password guarantees
that these devices cannot be tampered with.
The product can be loaded some hours after the unit has started its cooling cycle (check the temperature shown on the
display).
The unit is designed to display food products and so maintains the temperature of the product; it does not lower it. The
product should, therefore, only be loaded once the right storage temperature has been reached.
Never place glass bottles/containers or jars full of liquid in the BT versions as there is the risk that these may
explode/shatter.
Recommendations for storage:
- Never exceed the max load line on the inside of each compartment (see FIG. 12).
- Never block the cooling outlets that guarantee the correct flow of air (see FIG. 12.
- When loading a display unit that's already partially loaded, it's best to place the new products below those already
inside (as well as observing the above points).
- At night, switch off the lights in order to help energy savings.
The cabinet are provided, as a standard fitting, with an electronic control. The thermostat adjustment and the amount of
gas are set in the factory and any tampering with these settings will relieve the manufacturer of all responsibility.
9 - Prohibitions and requirements
Warning: disconnect the cabinet from the power supply in case it is not used. The power supply has to be disconnected
by the remote-control switch fitted upstream from the power socket.
Warning: Never expose the unit to atmospheric agents. Never use direct water jets to clean the unit. Never touch or use
the unit with wet or damp feet and hands.
Warning: Never remove the protections or covers that require tools to be removed. Never, under any circumstances,
remove the cover on the electronic panel.
Warning: Never load the unit excessively. Never stand on the cabinet.
Warning: Never try to remove any ice (that may build up) with sharp metal objects.
Warning: The refrigerating circuit does not alter the chemical composition of the water resulting from defrosting. This
comes exclusively from the steam contained in the air circulating inside the unit. In any case, this water should always be
disposed of down the drain or sent to a water purification plant in line with current local regulations.
Warning: Any use of the unit not explicitly mentioned in this manual should be considered dangerous and the
Manufacturer cannot be held liable for any damage resulting from improper, incorrect or unreasonable use.
Warning: Do not damage the refrigerant circuit (IEC60335-2-89 and changes).
Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the
type recommended by the manufacturer (IEC60335-2-89 and changes).
Warning: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Warning: Children should be supervised to ensure that they do not play with the appliance.
Warning: Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
10 - Defrosting of the unit and evaporation of any condensation
The defrosting cycle is indispensable for the refrigerating display unit to work properly and is controlled by the electronic
control. This uses armoured resistances on the evaporator to stop the electric condenser temporarily and so allow for the
evaporator to get rid of any built-up ice. The number of defrost cycles (standard is 3 cycles every 24 hours) is set in the
factory.
Regularly check the efficiency of the automatic defrosting cycle; if there are problems, call an expert technician.
The "plug-in" cabinets are equipped with an automatic evaporation system which eliminates the defrost water. At least
once a month check the level in the evaporator tray (this should be done with the cabinet off).
Warning: Only authorised service personnel are allowed to adjust or modify the unit.
Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the
type recommended by the manufacturer (IEC60335-2-89 and changes).
21