Transport - Trotec TTK 800 Manuel D'utilisation

Danger!
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Danger!
A toppling device can cause you injuries! Only slightly tilt
the device and move it carefully. If necessary, ask
another person to help. For longer distances, transport
the device with a fork lift or elevating truck. Never stand
below the device when suspended in the air.
Behaviour in the event of an emergency
1. Disconnect the device from the mains power in an emergency.
2. Do not reconnect a defective device to the mains power.

Transport

To make the device easier to transport, it is fitted with wheels and
a bar handle. If necessary, transport the device with the help of
another person. To lift the device, use a fork lift or an elevating
truck.
Before transporting the device, proceed as follows:
1. Switch off the device at the mains switch (see chapter
"Operating elements").
2. Remove the mains plug from the mains socket. Do not use the
power cable to drag the device!
3. Empty the condensation drain hose or the condensation pump
(optional). Check for dripping condensation.
4. If the device is standing in working position, hold the bar han-
dle with two hands and carefully lift the device into an upright
position.
5. Ensure that the stand bar is folded inwards and secured with
both safety rings (see chapter "Positioning").
6. Hold the bar handle in both hands again and tilt the device
lightly.
7. Transport the device on its wheels.
After transporting the device, proceed as follows:
1. Firstly, set the device in an upright position after transport.
2. Move the device to its working position (see chapter "Position-
ing").
3. Ensure that the rubber supporting surface of the stand bar lies
flat on the floor. The rubber supporting surface of the stand bar
prevents the device from rolling away.
B - 7
Storage
When out of use, store the device as follows:
• dry,
• with a roof overhead,
• in an upright position where it is protected from dust and direct
sunlight,
• with a plastic cover to protect it from invasive dust, if neces-
sary.
• The storage temperature is the same as the range given for the
operating temperature in the chapter "Technical data".
Operating Manual – Construction dryer TTK 800
EN