Bluetooth Settings; Devicelist; Add Device - Pioneer MVH-S300BT Mode D'emploi

• To cancel searching, press the M.C. dial.
• If the desired device is not in the list, select [RE-SEARCH].
• If there is no device available, [NOT FOUND] appears in the display.
5
Turn the M.C. dial to select a device from the device list, then press to confirm.
Press and hold the M.C. dial to switch the displayed device information between the
Bluetooth device address and device name.
If you make a Bluetooth connection from the unit, proceed to step 7.
6
Select [Pioneer BT Unit] shown in the device display.
7
Make sure the same 6-digit number appears on this unit and the device, then
select "Yes" on the device.
NOTES
• [DEVICE FULL] appears if the unit has already been paired with ten other devices. In this case, delete
one of the paired devices. See [DEL DEVICE] in the Bluetooth settings (page 14).
• Depending on the device, the PIN code is required in step 7. In this case, input [0000].
TIP
The Bluetooth connection can be also made by detecting the unit from the Bluetooth device. To do so,
[VISIBLE] in the Bluetooth settings needs to be set to [ON]. For details on Bluetooth device operations,
refer to the operating instructions supplied with the Bluetooth device.

Bluetooth settings

Menu Item

DEVICELIST

DEL DEVICE
[DELETE YES],
[DELETE NO]

ADD DEVICE

A.CONN
[ON], [OFF]
VISIBLE
[ON], [OFF]
Description
Display the list of paired Bluetooth devices. "*" appears on the
device name when the Bluetooth connection is established.
When no device is selected in the device list, this function is not
available.
Delete the device information.
Register a new device.
If ten devices are already paired, this function is not available.
You can check the number of paired devices on the [DEVICELIST]
setting.
Select [ON] to connect to a Bluetooth device automatically.
Select [ON] so that a Bluetooth device can detect the unit when
the unit is connected via Bluetooth to another device.
- 14 -