Atag CU90554TMM Notice D'utilisation page 54

MAINTENANCE
2
1
EN 12
Removing cassette filter
1. Switch off the motor and lighting.
2. Push in the latches and open the panel.
3. Open the filter's access latch. Support the filter with your hand.
4. Remove the filter from the hood.
Cleaning
The filters can be cleaned in the dishwasher. Allow the filters to drain
well before replacing.
The filters can also be cleaned by hand.
Clean the filters in soapy water with washing up liquid and rinse. Allow
the filters to drain well. See page 11 for instructions. The underside of
the cooker hood can be cleaned with a mild cleaning agent and a damp
cloth. Dry off with a paper towel.
Replacing cassette filter
The filter should be placed with the locking mechanism on the front.
Open the filter access latch. The notches at the front of the filter will
then slot in. Hold the access latch in this position when placing the
filters.
1. Slot the notches at the back of the filter in the specially designed
opening of the cooker hood.
2. Tilt the filter upwards.
3. Release the filter access hatch. The notches at the back of the
filter will extend outwards and slot into the specially designed
openings of the cooker hood. The filter is now in position again.
4. Press the glass plate firmly in the seal again (you will hear a click).
The glass plate can be removed for cleaning. Two people are
required when removing the glass plate (due to its weight)!
Active carbon filters:
The regenerable active carbon filter must be washed by hand with
neutral cleaning products, or in the dishwasher at a maximum
temperature of 65 °C (the washing should be done without any plates,
dishes, cups, etc. in the machine). Without washing detergent.
Remove the excess water without damaging the filter, remove the
holder and let the filter dry in the oven for at least 40 minutes at a
maximum temperature of 70 °C.