ShelterLogic AutoShelter RoundTop 1015 Manuel D'assemblage page 10

10. inSTAllinG coVeR WiTH coVeR RAilS
A. Lay the cover on the ground next to the frame with inside of the cover (the side with the pipe pockets) facing
down and the webbing on the front and rear of the corner of the building. Pull cover over the frame.
B. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself.
C. Disassemble cover rails and slide through fabric pockets at each leg and reattach with clamps to each leg.
Repeat this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.
D. Check and tighten Ratchets and Cross Rails monthly to ensure the cover is tight.
NOTE: The ShelterLogic
be oriented as shown below.
INCORRECT
Webbing and Ratchets Securing Cover
logo should
®
CORRECT
Middle
Rib
Cover
Rail
01010
01011
13201
10115
Cover
Rail
01011
01010
Page 10
COvER RAILS
13202
10115
Cover
Rail
01011
01010
End Rib
05_62689_0C