Adjusting The Airflow Direction - Sanyo KHS0971 Mode D'emploi

1. Horizontal
CAUTION
2. Vertical
A. Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
C. Auto flap function
The flap is set to the recommended
position.
CAUTION
OI-802-21EG

Adjusting the Airflow Direction

The horizontal airflow can be adjusted by moving the vertical vanes with your
hands to the left or right.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation may
begin to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote control
unit. Do not move the flap with your hands. Confirm that the remote control unit
has been turned on. Use the FLAP button to set either the sweep function or one
of the six airflow direction settings.
• The flap automatically closes when the unit is off.
NOTE
• During the heating operation, the fan speed will be very low and the flap will
be in the horizontal position (position
unit begins to warm. Once the air warms up, the flap position and fan speed
change to the settings specified with the remote control.
• Use the FLAP button on the remote control to adjust the position of the
flap. If you move the flap by hand, the flap position according to the
remote control and the actual flap position may no longer match. If this
should happen, shut off the unit, wait for the flap to close, and then turn
on the unit again; the flap position will now be normal again.
• Do not have the flap pointed down during cooling operation.
Condensation may begin to form around the air vent and drip down.
COOL
DRY
FAN
B. Setting the airflow manually
Referring to the above illustration, use the
FLAP button to set the airflow direction
within the range used during the heating,
cooling, or dehumidifying operation.
) until the air being blown out of the
SWEEP
SWEEP
HEAT
21