How To Remove The Battery Pack - Kokido Delta 200 Manuel D'utilisation

How to remove the battery pack (To be done by authorized technician)
Recommended tools (not included): Screwdriver.
1. Follow section "EMPTYING THE DEBRIS COMPARTMENT" to release the
top cover (preassembled with the swivel head). Place the cover upside down and
release the swivel head by turning its bottom locking plate anticlockwise. Remove
the swivel smoothing-ring.
2. Use the screwdriver to unscrew the 4 screws located at the bottom of the head
to release the bottom plate first. Then unscrew all the screws at the base as shown.
Remove the impeller and pry open the base to expose head inside.
3. Remove out the battery pack to expose the PCBA. To detach the battery
connection wire, press on the clip of the connector to pull it out. NOTE: Wrap the
connector immediately with insulating tape in order to avoid any short circuit caused
by the contact of both wire terminals.
18