Replacing The Spark Plug - Homelite UT10540 Manuel D'utilisation

CHECKING THE FUEL FILTER
See Figure 69.
Check the fuel filter periodically. If contaminated or
damaged, have fuel filter replaced by an authorized
service center.

REPLACING THE SPARK PLUG

See Figure 70.
This engine uses a Champion RCJ-6Y with .025
in. electrode gap. Use an exact replacement and
replace every 50 hours or more frequently, if
necessary.
 Loosen the spark plug by turning it counter-
clockwise with a wrench.
 Remove the spark plug.
 Hand thread the new spark plug, turning it
clockwise. Tighten securely with wrench.
NOTE: Be careful not to cross-thread the spark
plug. Cross-threading will seriously damage the
cylinder.
INSPECTING AND CLEANING CHAIN
BRAKE
See Figure 71.
 Always keep the chain brake mechanism clean
and lightly brush the linkage.
 Always test the chain brake performance after
cleaning. Refer to Operating Chain Brake for
additional information.
WARNING:
Even with daily cleaning of the mechanism, the
dependability of a chain brake to perform under
field conditions cannot be certified. Keep the
SAFE-T-TIP nose guard on the saw's guide bar
®
and use proper cutting techniques.
MAINTENANCE
Clean the Chain Brake
Page 36 — English
Fuel Filter
Fig. 69
Fig. 70
Fig. 71