Homelite UT10540 Manuel D'utilisation page 31

TOP PLATE FILING ANGLE
See Figure 53.
 CORRECT 30° – file holders are marked with
guide marks to align file properly to produce
correct top plate angle.
 LESS THAN 30° – for cross cutting.
 MORE THAN 30° – feathered edge dulls
quickly.
SIDE PLATE ANGLE
See Figure 54.
 CORRECT 80° – Produced automatically if you
use the correct diameter file in the file holder.
 HOOK – "Grabs" and dulls quickly; increases the
potential of KICKBACK. Results from using a file
with a diameter too small or a file held too low.
 BACKWARD SLOPE – Needs too much feed
top plate Filing angle
CorreCt
leSS than 30°
inCorreCt
Side plate Filing angle
CorreCt
hook
inCorreCt
MAINTENANCE
30°
more than 30°
Fig. 53
80°
BaCkward Slope
Fig. 54
Page 31 — English
pressure; causes excessive wear to the bar and
chain. Results from using a file with a diameter
too large or file held too high.
MAINTAINING DEPTH GAUGE
CLEARANCE
See Figure 55 - 57.
 Maintain the depth gauge at a clearance of .025
in. Use a depth gauge tool for checking the
depth gauge clearances.
 Every time the chain is filed, check the depth
gauge clearance.
 Use a flat file and a depth gauge jointer to lower
all gauges uniformly. Use a .025 in. depth gauge
jointer. After lowering each depth gauge, restore
original shape by rounding the front. Be careful
not to damage adjoining drive links with the
edge of the file.
 Depth gauges must be adjusted with the flat file in
the same direction the adjoining cutter was filed
with the round file. Use care not to contact cutter
face with flat file when adjusting depth gauges.
raker (depth gauge) ClearanCe
depth gauge jointer
.025 in.
Fig. 55
Flat File
Fig. 56
reStore original
Shape By rounding
the Front
Fig. 57