Connection Cable - Electrolux EHF3920BOK Notice D'utilisation

3.3 Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
3.4 Attaching the seal
1. Clean the worktop around the cut out
area.
3.5 Assembly
min.
500mm
2. Attach the supplied seal stripe to the
3. Add some mm when you cut the seal
4. Push the two ends of seal stripe
min.
50mm
min.
55mm
min.
28 mm
lower edge of the hob along the outer
edge of the glass ceramic. Do not
extend it. Make sure that the ends of
the seal stripe are located in the
middle of one side of the hob.
stripe to the length.
together.
R 5mm
+1
490 mm
+1
270 mm
min.
20 mm
ENGLISH 7
min.
12 mm