Efco MT 3500 Manuel D'utilisation Et D'entretien page 12

en
WARNING: WE DO NOT REPRESENT AND YOU SHOULD NOT ASSUME THAT THE CHAIN
BRAKE WILL PROTECT YOU IN THE EVENT OF A KICKBACK. DO NOT RELY UPON ANY OF
THE DEVICES BUILT INTO YOUR SAW. YOU SHOULD USE THE SAW PROPERLY AND
CAREFULLY TO AVOID KICKBACK.
Reduced-Kickback Guide Bar and Low-Kickback Chain
Reduced-kickback guide bars and low-kickback saw chains reduce the chance and magnitude of kickback
and are recommended. Your saw has a low kickback chain and bar as original equipment. Repairs on a chain
brake should be made by an authorized servicing dealer. Take your unit to the place of
purchase if purchased from a servicing dealer, or to the nearest authorized service dealer.
WARNING: Computed kickback angle (CKA) listed on your saw and listed in the CKA table
below represents angle of kickback your bar and chain combinations will have when tested
in accordance with CSA (Canadian Standards Association) and ANSI standards. When
purchasing replacement bar and chain, considerations should be given to the lower CKA
values. Lower CKA values represent safer angles to the user, higher values indicate more
angle and higher kick energies. Computed angles represented indicate total energy and
angle associated without activation of the chain brake during kickback. Activated angle
represents chain stopping time relative to activation angle of chain break and resulting kick
angle of saw. In all cases lower CKA values represent a safer operating environment for the
user. The following guide bar and chain combinations meet kickback requirements of
ANSI B175.1 when used on saws listed in this manual. Use of bar and chain combinations
other than those listed is not recommended and may not meet the CKA requirements per
standard.
WARNING: Do not mount a bow guide on any Efco chainsaw. The risk of kickback is
increased with a bow guide because of the increased kickback contact area.
Recommended bar and chain combination
Model Bar Length
MT 3500
MT 3500
12
SAFETY RULES
Oregon
Bar P/N
14" 140RCEA041
16" 160RCEA041
Chain
Drive Link Count
Pitch
3/8" x .050" 53
3/8" x .050" 57
CKA
Oregon
without Chain
Chain P/N
Brake
91 P - 52 E MAX 45°
91 P - 57 E MAX 45°