Starter Unit; Engine; Spark Plug; Spark Arresting Muffler - Efco MT 3500 Manuel D'utilisation Et D'entretien

MAINTENANCE

Starter Unit

89A
Use a brush to keep the cooling vents of the starter assembly free
and clean of debris (Fig. 90).
WARNING: The coil spring is under tension and
could fly apart causing serious injuries. Never try to
disassembly or modify it.

Engine

Clean the cylinder & flywheel fins with compressed air or a brush
periodically (Fig. 91). Dangerous overheating of engine may occur
due to impurities on the cylinder.
90
WARNING: Never run the saw without all the parts,
including the drivecase cover and starting housing,
securely in place. Because parts can fracture and
pose a danger of thrown objects, leave repairs to the
flywheel and clutch to trained Servicing Dealers.

Spark Plug

This engine uses a Champion RCJ-7Y with .02" (0.5 mm) electrode
gap (Fig. 92). Use an exact replacement and replace every six
months or more frequently, if necessary.
91
WARNING: Never test the ignition system with
ignition wire connector removed from spark plug or
with unseated spark plug, since uncontained
sparking may cause a fire. A loose connection
between spark plug terminal and ignition wire
connector in the boot may create arcing that could
ignite combustible fumes and cause a fire.
Use only resistor type spark plugs of the approved range.
Factors such as:
- too much oil in fuel mix;
- dirty air filter;
- unfavourable running conditions, e.g. operating at part load;
may result in rapid deterioration of the spark plug.

Spark Arresting Muffler

The chainsaw is provided with a Spark Arrester System p.n.
50240109 (Fig. 93) complying with the requirements of SAE J335
standard; you can check the p.n. of the Spark Arrester System on
the muffler itself.
92
WARNING: A faulty or altered spark arrester system
screen can create a fire hazard.
93
Through normal use the screen can become dirty and should be
inspected weekly and cleaned as required.
To clean:
• Allow the muffler to cool.
• Remove the three (3) muffler screws (B).
• Remove the protection (C).
• Remove the spark arrester screen screw (D).
• Remove the spark arrester screen (A) p.n. 50240155.
• Clean and inspect the spark arrester screen. If the spark arrester
screen is damaged, faulty or deteriorated, replace the screen.
en
33