Installation Examples; Coil Rotation - AERMEC Omnia HL PC Manuel D'utilisation Et D'installation

INSTALLATION EXAMPLES

HL_PC / HL_PCM
wall-mounted
installation
HL_PC / HL_PCM
wall-mounted
installation,
without skirting
with feet
(ZH1 / ZH1B)

COIL ROTATION

If the hydraulic connections require
the rotation of the coil, remove the
cabinet and ambient probe then
proceed as follows:
– remove the electrical connections
from the terminal strip;
– remove the probe from the coil;
– remove the screws fixing the basin
and remove it;
– remove the screws securing the coil,
then remove the coil;
– r e m ove t h e p u s h - o u t s o n t h e
righthand side;
– rotate the coil and secure it with the
previously removed screws;
INSTALLING THE ELECTROSTATICALLY PRECHARGED AIR FILTER
•
Installation
- Remove the ventilation grille from the
unit. Use the point of a tool to place
pressure on the upper hooks of the
grille.
- Remove the filter from its sealed pack-
age.
- Insert the filter in the suction grille.
- Reattach the ventilation grille to the
unit. First insert the lower hooks of the
cover, and then insert the upper hooks.
•
Characteristics
Class 2 (UL 900).
– reassemble the tray, fixing it with the
screws. All the trays are suitable for
condensate drainage on both sides;
N . B . : B e f o r e c o n n e c t i n g t h e
condensate discharge, use a tool to
knock out the diaphragm of the tray
on the water connections side.
– position the polyethylene cap of
the condensate discharge onto the
lefthand side;
– remove the electric motor cable from
the right-hand side;
– remove the rectangular push-out from
the left-hand side;
– recover the cable grommet and insert
Easy to remove, it is supplied in a
sealed box only to be opened when it
is to be used.
The electrostatic precharge of the
filter is spent after two years of the
box being opened, after this period it
behaves like a normal filter.
For this reason replacement over
two years with a new one is
recommended (available as a spare
part from Aermec After Sales centres).
HL_PC / HL_PCM
ceiling installation
HL_PC / HL_PCM
(ZH1M / ZH1MB)
it in the left-hand side before closing
the right-hand hole with adhesive
tape;
– move the electric motor cable onto
the left-hand side, passing it through
the cable grommet and arranging it so
it reaches the connector on the side;
– unravel the twists and turns of the
microswitch cable for the length
necessary to reach the control board
on the left-hand side;
– fasten the microswitch cable to the
cable clamps.
•
Maintenance
Cleaning frequently, removing
the dust that has built up using
a vacuum, the use of water and
cleaning substances considerably
speeds up the electrostatic precharge
deterioration.
IHLPCLJ 1809 - 6887206_04
wall-mounted
installation with
skirting and feet
27