Extraction - Atag HIDD8471LV Instructions D'utilisation Et De Montage

5.2 Extraction

Cleaning the grease fi lters
Clean the grease fi lter in the dishwasher or in mild soapy
water at least once a month or in the event of excessive
grease deposits and/or intensive use.
Lift the extraction hood before removing the fi lter. This
makes it easy to remove the fi lter for cleaning.
NOTE
Do not place the glass cover too fi rmly. Risk of glass
breakage.
The fi lter can be rinsed in a dishwasher. Turning the
fi lters in the dishwasher upside down. Please use only
rinse aid that is suitable for RVS use with aluminium in
order to avoid damaging and discolouring the fi lters.
Never rinse right next to glasses or light-coloured
porcelain.
Do not operate the extractor without grease fi lters!
After rinsing the fi lter, dry it and replace it in the extractor.
Please make sure that the recessed handle is visible
after you have replaced the fi lter. If possible, wipe the
easily accessible inside of the extractor with a cloth
dampened with detergent every time you replace a fi lter,
while at the same time paying attention to protruding
parts in the inside of the extractor.
Cleaning and care
Cleaning and care of the extraction housing
The extraction housing is best cleaned every time you
clean the fi lters.
Condensation water may collect under the extraction
housing after water has boiled rapidly with the lid of the
pot removed. This is quite normal. The water should,
however, be removed and the inside of the extraction
housing cleaned.
Failure to clean the grease fi lter and the housing in
good time can lead to unpleasant odours at rest and at
the beginning of the extraction process. It is therefore
advisable to carry out this cleaning at least once a month.
It is best to clean the housing with a damp, soft cloth and
mild detergent solution.
Service
The recirculating air fi lter must remain accessible.
Glass cover
Replace the charcoal fi lter mats of a charcoal fi lter every
5 to 24 months. This strongly depends on the cooking
behaviour of the user (intensity and regularity).
Removable bottom
The bottom can be removed for cleaning.
Switch off the hob and extractor and remove the glass
cover and the fi lter.
Hold the bottom fi rmly with one hand from below and
open the 4 locks with the other hand. After opening,
hold the bottom horizontally and carefully remove it
downwards.
Drain any liquids and thoroughly remove any impurities.
Clean the accessible inside of the housing. Optionally,
the bottom can be cleaned in the dishwasher.
It must be reset in place after cleaning and attached with
the 4 closures.
GB
47