Table des Matières
Publicité
OP1
OP2
OP3
(5)
(6)
(4)
(7)
OP4
26
(1)
(2)
(3)
BCZ2601S
BCZ2601SU
(7)
(4)
(6)
(5)
BCZ2601SW
English
8. Operation
■ STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine
starts.
1. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
2. Push the primer pump several times until overflown
fuel flows out in the clear tube. (OP1)
3. Move the choke lever to the closed position. (OP2)
4. Set the ignition switch to the "Start" position. While
pulling the throttle lever, push the throttle set button,
and release the throttle, then the throttle lever is in to
the "Start position". (OP3)
5. While holding the unit firmly, pull out the starter rope
quickly until engine fires. (OP4)
(1) choke lever
(2) close
(3) open
(4) ignition switch
(5) start
(6) stop
(7) Throttle set button
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
6. Move the choke lever downward to open the choke.
And restart engine. (OP2)
7. Allow the engine to warm up for several minutes
before starting operation.
NOTE
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
Publicité
Table des Matières
