Start The Washer - Maytag MAV-2 Guide D'utilisation Et D'entretien

Using the Controls –
STEP 5
Soak Only
Provides approximately 33 minutes of alternating
periods of soaking with brief agitation at slow speed.
At the end of the cycle, the cycle selector dial must be
manually set to a wash cycle or spin cycle to drain the
washer. Avoid extended soaking.
Spin Only
Provides a spin to remove more water from the load.
Rinse & Spin
Use for loads that need rinsing only or to add rinse-
added fabric softener to a load.
Power Off
To cancel the cycle and turn off the washer, turn the
Cycle Selector dial to Power Off and push the dial in.
9
Electronic Control Models
STEP 6
Select Options
Extra Rinse
When the knob is in the On position, an
additional rinse at the end of all cycles is
provided to more completely remove
laundry additives, suds, perfumes, etc.
End of Cycle Signal
The end of cycle signal will sound once the
cycle is completed. On select models, the end
of cycle signal can be canceled by setting the
switch to Off.
STEP 7

Start the Washer

To start the washer, press the cycle selector dial.
Changing a Cycle
If an incorrect cycle has been accidentally
selected:
1. Press the cycle selector dial.
2. Turn the cycle selector dial to the desired cycle.
3. Set the desired options for the cycle.
4. Press the cycle selector dial. The Wash indicator
lights stop flashing and the new cycle starts.
Canceling a Cycle
To cancel a cycle:
1. Press the cycle selector dial.
2. Turn the cycle selector dial to Power Off and push
the dial in.
To drain the washer:
1. Select the Rinse and Spin or Spin Only cycle.
2. Press the cycle selector dial. The Spin light
illuminates and the washer starts the rinse or spin.
(if desired)