Astralpool 35451 Manuel D'installation Et D'entretien page 5

NOTE: The spotlight is equipped with a heat protection device that, in the event of excess temperature, reduces the lighting level to
prevent overheating.
5.2.3 Receiver-modulator (code 27818)
Install the Receiver-Modulator where it is protected from corrosion, outside metal boxes
and at a distance from metal pipes or electrical cables that can block the Radio
Frequency signal from the remote control.
Operation of the Pushbuttons:
OFF:
• To turn off the spotlight.
• By keeping this button pressed (whether the spotlight is on or off), the receiver
enters the "Instruction" mode, that starts-up the remote control by pressing once
any key of the Control (See "Start-up").
ON / COLOUR:
• If the spotlight is off or in the SEQUENCE mode, the spotlight is turned on in the SET COLOUR mode (the activated colour
will be the last set colour used).
• If the spotlight is already in the SET COLOUR mode, press the button to change the colour within the 12 different options.
ON / SEQUENCE:
• If the spotlight is off or in the SET COLOUR mode, the spotlight is switched on in the SEQUENCE mode. (The activated
programme will be the last one used) (programme or colour changes in the sequence should be performed from the remote
control).
ON / TIMER:
• If the spotlight is off, it is switched on in the last operation mode used and the TIMER function is activated, switching it off
automatically after a time pre-set from the remote control. (Duration changes of the timer must be performed from the
remote control).
• If the spotlight is in SET COLOUR or SEQUENCE mode, the TIMER function is activated.
NOTE: The Remote Control must remain off when the Receiver-Modulator pushbuttons are being used.
LED indicator: By observing the green led of the Receiver-Modulator, you can determine the spotlight operation status:
•
Led off:
•
Flashing every 2 sec.
•
Led on without flashing:
•
Slow flashing:
•
Quick flashing:
•
Flashing for 2 sec.
5.2.4 Remote control (code 27817)
Technical specifications:
Description of the keypad:
ON / OFF key: If the remote control is off, this key switches it on sending the last order run. If it is on,
the remote control is turned off without switching off the spotlight. It will switch off if no button is
pressed for more than one minute.
COL (COLOUR) key: This key activates the SET COLOUR mode. A colour can be selected from the
following table by pressing it successively:
The following will be displayed: C01, C02 .....C12 depending on the colour selected.
SEC (SEQUENCE) key: This activates the SEQUENCE MODE and enables you to select one of the nine
different programmes available. Each programme is defined by a timer that determines the duration in
which a colour is on, and another timer to determine the blending and transition time to the next colour.
The following will be displayed: P-1, P-2 .......P-9, depending on the programme selected.
ACT (COLOUR ACTIVATOR) key: This activates or deactivates the presence of the colours in the sequence. . A maximum of 12
colours can be used in the sequence, and if you do not want some of these colours to form part of the sequence, you can deactivate
them using this key.
When a colour is activated, it is shown in the display with an upper case C, and if it is deactivated it appears with a lower case c. For
example: C05 (activated) or c05 (disabled).
Power supply is disconnected.
Spotlights with leds off.
Spotlight in SET COLOUR or SEQUENCE mode.
TIMER function on.
INSTRUCTION function
Receiving order from the remote control.
Operation frequency:
Scope in the open:
Battery:
433 MHz
50 m.
9 Vdc type 6LR61.
5