Signature SRUS5000XAQUA Instructions D'utilisation page 58

Problem
The motor
runs
continuously
A layer of
frost occurs in
the
appliance
Temperature
inside is too
warm
Temperature
inside is too
cold
Doors can't
be closed
easily
Water drips
on the floor
Possible cause & Solution
· Large quantity of warm food has
recently been stored within the
appliance.
· The temperature outside the
appliance is too high.
· Doors are kept open too long or too
often.
· After your installing the appliance or
it has been switched off for a long time.
Check that the air outlets are not
blocked by food and ensure food is
placed within the appliance to allow
sufficient ventilation. Ensure that door is
fully closed. To remove the frost, please
refer to cleaning and care chapter.
You may have left the doors open too
long or too frequently; or the doors are
kept open by some obstacle; or the
appliance is located with insufficient
clearance at the sides, back and top.
Increase the temperature by following
the "Display controls" chapter.
Check whether the top of the
refrigerator is tilted back by 10-15mm to
allow the doors to self close, or if
something inside is preventing the doors
from closing.
The water pan(located at the rear
bottom of the cabinet)may not be
properly positioned to direct water into
this pan, or the water spout is blocked.
You may need to pull the refrigerator
away from the wall to check the pan
and spout.
-56-