Troubleshooting - Signature SRUS5000XAQUA Instructions D'utilisation

Replacing the LED light
Warning: The LED light must not be replaced by the
user! If the LED light is damaged, contact the
customer helpline for assistance. To replace the LED
light, the below steps can be followed:
1. Unplug your appliance.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and pull it with
the other hand while pressing the connector latch.
4. Replace LED light and snap it correctly in place.

TROUBLESHOOTING

If you experience a problem with your appliance or
are concerned that the appliance is not functioning
correctly, you can carry out some easy checks before
calling for service, please see below. You can carry
out some easy checks according to this section before
calling for service.
Warning! Don't try to repair the appliance yourself. If
the problem persists after you have made the checks
mentioned below, contact a qualified electrician,
authorized service engineer or the shop where you
purchased the product.
Problem
Appliance
is not
working
correctly
Possible cause & Solution
Check whether the power cord is
plugged into the power outlet properly.
Check the fuse or circuit of your power
supply, replace if necessary.
The ambient temperature is too low. Try
setting the chamber temperature to a
colder level to solve this problem.
-54-