Bresser Junior Biolux ICD Pro 20x/50x Mode D'emploi page 11

Illumination
Remove both eyepieces (3) from the
eyepiece supports (1) and turn the en-
tire microscope over. In the base of the
microscope there is a battery compart-
ment (9). Loosen the 6 fixing screws
(10) of the battery compartment cover
and remove the cover.
Place the batteries in the compart-
ment so that the flat minus poles (-)
press against the spring terminal and
the plus poles (+) are touching the flat
contact sheets (11).
Put on the cover and fix it with the 6
screws (10). Turn the microscope over
again. Place the eyepieces back on.
You can not turn on the light (4) with
the on/off switch (8) on the base of the
microscope.
Experiments
Use the following web link to find in-
teresting experiments you can try out:
http://www.bresser.de/downloads
TIPS on cleaning
Remove the device from it's
energy source before clean-
ing (remove batteries).
Clean the exterior of device with a dry
cloth. Do not use cleaning fluids so as
to avoid causing damage to electronic
components.
Protect the device from dust and
moisture. Store the device in the bag
supplied or in its original packaging.
Batteries should be removed from the
device if it is not going to be used for a
long period of time.
Clean the lens (objective and eye-
piece) only with the cloth supplied or
some other soft lint-free cloth (e.g.
micro-fibre). Do not use excessive
pressure - this may scratch the lens.
Dampen the cleaning cloth with a
spectacle cleaning fluid and use it on
very dirty lenses.
EN
11