AKO 15740 Manuel D'utilisation page 31

Maximum alarm delay:
(Only for NTC, Pt100, Pt1000 and 4-20mA)
Configures the delay time from when the maximum value is reached until the alarm is activated.
(in minutes)
Enable min. alarm:
(Only for NTC, Pt100, Pt1000 and 4-20mA)
Allows you to enable the minimum value reached alarm. (If you select "Disabled", on confirming, the wizard
will appear).
Minimum alarm:
(Only for NTC, Pt100, Pt1000 and 4-20mA)
Defines the minimum value at which the alarm will be activated.
Minimum alarm delay:
(Only for NTC, Pt100, Pt1000 and 4-20mA)
Configures the delay time from when the minimum value is reached until the alarm is activated. (in minutes)
Value at 4mA:
(Only for 4-20mA)
Defines the equivalent value of the 4-20mA converter for a 4mA current (see characteristics of the converter
used).
Value at 20mA:
(Only for 4-20mA)
Defines the equivalent value of the 4-20mA converter for a 20mA current (see characteristics of the
converter used).
Dig. input polarity:
(Only for digital)
Defines the type of contact connected to the input (normally open or normally closed).
Activation delay:
(Digital only)
Defines the delay (in minutes) from the activation of the input to the generation of an event. This delay also
affects the activation of the maximum alarm relay and the buzzer.
Deactivation delay:
(Digital only)
Defines the delay (in minutes) from the deactivation of the input to the generation of an event. This delay
also affects the deactivation of the maximum alarm relay and the buzzer.
Alarm relay:
(Digital only)
Defines whether the maximum alarm relay is activated (terminals 31, 32 and 33) when an activation event is
generated.
Alarm buzzer:
(Digital only)
Defines whether an audible alarm is activated when an activation event is generated.
After confirming the last parameter, the wizard ends and goes back to the programming menu.
31