Custom Panel Dimensions - KitchenAid W10520792D Guide D'utilisation Et D'entretien

2. Style 1—For gravity drain system, push the ice maker into
position so that the ice maker drain tube is positioned over
the PVC drain reducer. See "Gravity Drain System."
Style 2—For drain pump system connect the drain pump
outlet hose to the drain. See "Drain Pump System."
3. Recheck the ice maker to be sure that it is level. See
"Leveling."
4. If it is required by your local sanitation code, seal the cabinet
to the floor with an approved caulking compound after all
water and electrical connections have been made.

Custom Panel Dimensions

If you plan to install a custom overlay panel, you will need to
make the panel yourself or consult a qualified cabinetmaker or
carpenter.
IMPORTANT:
The thickness of the overlay panel must be 3/4" (1.91 cm).
■
Overlay panel must not weigh more than 8 lbs (3.62 kg).
■
Overlay panels weighing more than recommended may cause
■
damage to your ice maker.
Match wood grain direction with that of adjacent cabinets.
■
Sand panel edges to provide a smooth finish.
■
Use moisture sealer on both sides and all edges of the panel
■
to avoid damage from moisture.
Option 1—Without Hinge-Side Spacer
To allow proper clearance for the door, prepare the custom
overlay panel using the dimensions shown.
"
1¹⁄₄
(3.18 cm)
³⁄₄ "
(1.91 cm)
"
¹⁄₄
(6.35 mm)
10
29
¹⁄₂
(74.9 cm)
14¹⁷ "
⁄₃₂
(36.9 cm)
"
1¹⁄₄
(3.18 cm)
³⁄₄ "
(1.91 cm)
"
¹⁄₄
(6.35 mm)
Option 2—With Hinge-Side Spacer
To achieve a flush installation with adjacent cabinets, prepare the
custom overlay panel using the dimensions shown.
Front of Panel
Top of Panel
A. Front—visible surface when installed
B. Hinge side
"
Bottom of Panel
A. Front—visible surface when installed
B. Hinge side
14 "
⁵⁄₈
(37.1 cm)
A
A
29 "
¹⁄₂
(74.9 cm)
B
B