Cola Ferroli TERMONOVARA Manuel D'installation, D'utilisation Et D'entretien page 49

Button Description
Increase
temperature
Decrease
temperature
Setting/menu
ON/OFF
reset
Decrease
power
Increase
power
The Figure opposite describes the meaning of the status
indicators in the left part of the display.
Activation of one of the segments on the display signals
activation of the corresponding device according to the list
opposite.
4.3 Lighting
4.3.1Check before lighting
Before lighting the stove:
- make sure you have read and understood that given in the manual;
- the hopper must be filled with pellets;
- the combustion chamber must be clean;
- the brazier must be completely free, cleaned of any combustion residuals and correctly fitted in the brazier
holder;
- check hermetic closing of the fire door and ash pan;
- check the connection of the power cable and switching to ON/1 of the switch located on the back of the stove.
- check opening of the delivery and return shutoff valves as well as the water circuit pressure.
- At first startup, remove all the components (instructions/label) that could burn from the stove firebox and
glass.
- Any lightings done after long stove idle periods require the renewal of any pellets that have been inside
the hopper for a long time, in being a damp fuel no longer suitable for combustion, and complete
cleaning of the combustion chamber.
Mode
TEMPERATURE
Increases the room and water thermostat temperature value
SETTING
PROGRAMMING Increases the selected parameter
WORK Displays temperatures
TEMPERATURE
Decreases the room and water thermostat temperature value
SETTING
PROGRAMMING
Decreases the selected parameter
WORK
Displays stove operation status
Access the temperature SETTING and user and technician
parameters menu by successive pressing
Press for 2 seconds to switch the stove on or off (if off or on)
WORK
Resets the stove and returns it to off status
BLOCK
Exits the programming menu at any point of modification.
PROGRAMMING
The changes are saved
WORK
Decrease output or the DHW boiler water thermostat
Decrease output or the DHW boiler water thermostat
Temperature value (if enabled)
Increase output or the DHW boiler water thermostat Increase output or the DHW boiler water thermostat
WORK
Temperature value (if enabled)
Action
Temperature value (if enabled)
Temperature value (if enabled)
49
Top display Bottom display
Sanitary SET
Temperature
Sanitary SET
Temperature
External contact
Chrono
Electrical element
Auger
Fume extractor
DHW circuit activation
HEATING circuit activation
ALARM
TERMO-NOVARA
Limits