aldes VMC double flux Dee Fly Compact Hygro Notice De Montage page 31

RIGID DUCT ASSEMBLY
Ductwork in heated spaces: using rigid
circular ductworks or miniducts
Strongly recommended for thermal efficiency reasons.
Use of miniduct ducts and accessories in order to facilitate
the integration of the ductwork into the heated spaces and
limit pressure losses.
Screwed in at two
points
Flat duct 40x100
Plug
Flat duct
40x100
60x200
Grille connections
The grilles should be connected to the miniduct network using an appropriate miniduct/grille connector
Flat duct
100 x 40
BIO Design Ø 80
RF Ø 125
Single screw with duct
clipped into the bracket
PVC Adhesive
Vertical band 90°
Flat duct
for grilles
200 x 60
Manchette
Direct connection using the miniduct range elbow bends
trident Ø 125
Connection using the appropriate accessories when it is too far
from the ductwork to the grille
BAHIA
Ø 125
10
6
9
11
Distribution casing
Use of the flat 3 or 6 connector distribution casing
• Connections using miniducts
• Integrates into suspended ceiling voids
• H < 100 mm
• Mounting the distribution casing to the ceiling using threaded
studs
Vertical band 90°
for grilles
BAP'SI
Ø 125
Warning. Do not forget to connect the kitchen grille
electrically. On first use it is necessary to wait 15 mins
after powering on before being able to use the
kitchen electric grille.
31
7
8
3
5
4 2
Duct mounting and connections
Use the flange.
To interconnect the miniducts and
provide a good seal, use PVC tape or
compatible adhesives.
1