aldes VMC double flux Dee Fly Compact Hygro Notice De Montage page 29

WALL MOUNTING (horizontal)
Prohibited assemblies
Horizontal wall mounting of the heat exchanger
• Compulsory option: Dee Fly floor-mounting kit.
Plan for one kit per casing (code 11023144)
• Compulsory option: condensate evacuation kit for
horizontal wall mounting
• Feet mounted on each end of the casing using
screws (supplied)
• Anti-vibration mounts are used to separate the
motor from the wall to limit
the transmission of noise
• Install the condensate recovery
described in the instructions delivered with the
condensate evacuation kit for horizontal wall
mounting (code 11023099)
• Screw in the condensate evacuation nozzle
• Assemble the water trap to the bend. This water
trap runs without any water.
Be carreful to the direction (arrow)
• The water trap need to be impervious, and not at
the atmospheric pressure
29
tank as
Be careful that the direction
of the exchanger and motor
are correct! Whether in an
assembled or dissociated
configuration, the exchanger
and motor must always
be in the same position
to each other.