aldes VMC double flux Dee Fly Compact Hygro Notice De Montage page 26

ASSEMBLY
Prohibited assemblies
Be careful that the direction of the exchanger and
motor are correct! Whether in an assembled or
dissociated configuration, the exchanger and motor
must always be in the same position to each other.
Assembled fitting
• Remove the fresh air and
from the heat exchanger
• Remove the connector seals and place them on the motor casing
connectors
• Clip the motor onto the heat exchanger
• It is possible to link the exchanger to the motor. Fit the brackets
onto the motor using 2 screws, the locking system onto the
exchanger and fit the 2 elements together (supplied)
• Make sure the 2 casings are aligned.
On-line fitting
• Facilitates the integration of the exchanger into
the heated space
• Used to install the motor in a technical area
(attic, garage...)
• To limit the transmission of vibrations, use
flexible ducts or sleeves for aeraulic connections
to the motor casing
• After this connection, use preferably rigid ducts
to limit the pressure losses
26
Make sure to respect
the mounting direction
of the ventilation casing.
Direction indicated
using adhesive next
to the connectors
exhaust connectors