Technical Characteristics; Performance Features - Perry Electric 1GA 47917MET/P Instructions Pour L'installation Et Mode D'emploi

TECHNICAL CHARACTERISTICS

Supply voltage:
Solenoid valve control relay:
Relay contact capacity (max):
Protection category:
Insulation:
Buzzer:
G
Environment of application:
B
Operating temperature:
Operating humidity:
Types of gas detected:
Alarm level:
Sensor warm-up time at power-on:
BUS connections
Max BUS configuration:
Max connection length:
Reference standards for CE marking:
PRINCIPAL SIGNALS AND CONTROLS
LED indicators
and buzzers
LED BUZZER
Off
intermittent
permanently
alight
ON - TEST selector
(Fig. 1)
14
230 V~ 50 ÷ 60 Hz
1 changeover contact, zero potential
8 (2) A / 250 V ~
6 (2) A / 250 V ~ semi flush-mounted
IP 42
IP 40 semi flush-mounted
Class II
85 dB at 1 metre
Household or similar
-10 °C ÷ +40 °C
90% RH (maximum)
Natural gas - for Natural gas model
LPG - for LPG model
10% LEL - ( ower xplosive imit) L E L
1 minute
1 main unit with 14 remote units
2
1 km (with 2 wires of 1.5 mm section)
LVD EN 50194
CEI 216-8 semi flush-mounted
EMC EN 50270
ON

PERFORMANCE FEATURES

Performance (both models):
- Alarm memory
- Clear alarm memory
- Prepared for BUS connections
Principal controls
"Reset" button:
- Clear alarm memory
- Appliance replacement warning signal overriding
- System configuration with BUS connection
Slide selector:
- Test installation
- System configuration with BUS connection
Other luminous signals:
- Alarm memory
- Sensor warm up time
- Appliance and/or BUS fault
- Replacement warning
(* - with audible signal)
Green Led - Mains active
Yellow Led - Appliance fault
Red Led 1 - Alarm status
Red Led 2 - Low presence of gas
Red Led 3 - Very low presence of gas
TEST RESET
RESET button
more than 5 years (*)
- Sensor warm-up time