Installation Instructions - Perry Electric 1GA 47917MET/P Instructions Pour L'installation Et Mode D'emploi

7.u - ADVICES FOR CORRECT USE
• DO NOT bring cloths soaked with Alcohol, Acetone, Ammonia,
Bleach or Solvents into the proximity of the appliance.
• DO NOT use any kind of SPRAY near the gas detector.
• DO NOT carry out an operational test on the gas detector by
releasing gas directly from the gas pipe, lighters or lighter refill
cans.
• Cooking vapours and pollutant dusts can affect the
performance of the sensor over time.
• DO NOT ATTEMP TO OPEN THE CABINET: danger of electric
shock and malfunctions.
• On a periodic basis, check that the vents on the front panel of
the detector, which channel air to the sensor, are not
obstructed by dust or grease, etc.
• To clean this device make use of a lightly wet tissue.

INSTALLATION INSTRUCTIONS

surface mounted
OVERALL DIMENSIONS
82
ON TEST RESET
120
1.i - INSTALLATION OPERATIONS
CURRENTLY
COUNTRY COVERING THE INSTALLATION AND USE OF GAS POWERED
EQUIPMENT ARE TO BE RESPECTED, AS ARE STANDARDS COVERING SMOKE
DISPERSION AND VENTILATION OF ENCLOSED AREAS, EVEN THOUGH GAS
DETECTION EQUIPMENT IS INSTALLED.
30 cm
Natural gas detector
LPG detector
30 cm
•
Install
•
Install
•
Install detectors from 1 to 4 m from gas appliances.
•
Do not install the detectors outdoors or in places exposed to atmospheric agents.
•
Do not install the detectors near: sink, air vents, HVAC appliances or windows;
furthermore, the detectors must not be installed in
semi flush mounted
enclosed spaces, such as behind a curtain
(with optional support may
or inside a closet.
be purchased separately)
Fig. 12
Example of installation with 3 gas
detectors connected through BUS.
A - Main unit with solenoid valve
control.
B - Remote unit
C - Remote unit
40
27,5
NATIONAL STANDARDS ENFORCEABLE IN THE INSTALLATION
min. 1 m
max. 4 m
ON TEST RESET
ON TEST
min. 1 m
ON TEST
ON TEST RESET max. 4 m
Natural Gas detector max. 30 cm from ceiling
LPG detector max. 30 cm from floor .
ON TEST RESET
BUS
A
1
Solenoid
2
valve
ON TEST RESET
B
ON TEST RESET
G
RESET
B
ON TEST RESET
RESET
ON TEST RESET
Fig. 11
.
ON TEST RESET
C
BUS
Boiler
17