Adjustment Of Idling - Dolmar PB-251.4 Instructions D'emploi

• The engine may be damaged if the choke lever is moved further beyond the "CLOSE" position.
• If the engine stops with an explosion sound or if the engine started, but stopped before operation of the choke lever, return this lever to
the "OPEN" position and pull the starter handle several times to start the engine again.
• If the operator keeps pulling the starter handle several times with the choke lever left in the "CLOSE" position, the engine may be difficult
to start because of over-suction of the fuel.
• In case of over-suction of the fuel, remove the spark plug and pull the handle several times rapidly to discharge any excess fuel. Dry
the spark plug electrode.
• When the throttle valve does not return to a position in contact with the idling adjusting screw even if the throttle lever is set to the low
speed, correct the control cable catching state to ensure proper return of the valve.
2) When the engine is warm
(1) Place the engine on a flat ground.
(2) Press the primary pump several times.
(3) Confirm that the choke lever is open.
(4) Hold the main handle with a left hand to prevent the engine from moving, settle down to take the stable position.
(5) Pull out slowly the starter handle till a certain resistance is felt. Return the starter handle backward once from this position, then pull it
out with force.
(6) When the engine is difficult to start, open the throttle valve by about 1/3.
2. Stopping
1) When the cruise control lever is OFF
Release the trigger lever to reduce the engine speed, and set the
stop switch to the "O" position.
2) When the cruise control lever is ON
Set the cruise control lever to the OFF position, reduce the engine
speed, and set the stop switch to the "O" position.

ADJUSTMENT OF IDLING

The carburetor is the adjustment being completed at the time of factory shipment. Please do not adjust other than idling adjusting. When
adjustment becomes necessary, please consult your dealership or an authorized service agent.
Checkup of low-speed rotation
Set the low-speed rotation to 3500 ( /min).
• If it is necessary to change the rotation speed, regulate the
adjusting screw, with Phillips screwdriver.
• Turn the adjusting screw to the right, and the engine rotation will
increase. Turn the adjusting screw to the left, and the engine
rotation will drop.
NOTE
OFF
DANGER
Carburetor
12
Cruise control lever
ON
Adjusting screw