Triton TPT 125 Instructions D'utilisation Et Consignes De Sécurité page 6

ASSEMBLY
Unpacking
Carefully unpack and inspect your tool. Familiarise
yourself with all its features and functions.
Ensure that all parts of the tool are present and in good
condition. If any parts are missing or damaged, have such
parts replaced before attempting to use this tool.
Bench mounting
• Set up the unit on a firm,
flat surface so that the
table is horizontal and the
unit cannot tip over
• When siting the tool in a
permanent position, ensure
that it is fixed to a rigid
work surface
1. Use the holes in the base
of the planer/thicknesser as a template to mark and
drill four holes in your intended mounting surface (i.e.
workbench). Secure the unit in position using large
bolts, washers and nuts (not supplied)
2. If the planer/thicknesser is intended to be portable, fix
a board to the base which can be easily clamped and
removed from various mounting surfaces
3. Ensure bolts are long enough to penetrate the
workbench or board sufficiently for a secure fix
SAFETY
Important guidance for safe use of this tool
• Disconnect the machine from power source whenever
adjusting or replacing any parts
• Ensure the On/Off Switch is in the 'OFF' position before
connecting the tool to mains power
• Keep hands away from all moving parts
• Wear eye protection and a face mask when using this
tool
• Make sure all mobile parts move freely and are free
from interference
• Keep blades sharp, aligned and correctly secured to the
cutter head
GB
• Never turn the machine on with the workpiece in
contact with the blades
• Whenever the planer is not in use, switch off and
disconnect from power
• Keep the planer in good order. Follow the maintenance
instructions (see 'Maintenance')
Assembly / Safety
6
Attaching the crank handle
Mount the Crank Handle (9) in position (see main image)
on the right hand side of the planer:
1. Thread spring washer onto
Crank Handle Retaining Bolt
(7)
2. Fit the crank handle onto
the gear screw
3. Use the bolt to secure the
crank handle in position.
Use the Hex Key (15) to
tighten the bolt
4. Insert the Crank Handle Fixing Cap (8) to conceal the
fixing
Fig.1
Attaching the dust chute
The Dust Chute (5) can be mounted for extraction of
waste at either end of the planer
1. Use the 2 x Dust Chute
Thumb Screws (6) to mount
the dust chute onto the
Rollercase (1) using the Dust
Chute Fixing Positions (18)
2. Having fixed the chute in
position, connect the dust
extraction hose
3. Turn the extract system on
before operating the planer
Circuit breaker
• A circuit breaker is installed next to the On/Off Switch
(13)
• If excessive electric current is detected, the circuit
breaker will shut off the power supply to protect the
motor
• Before resetting the circuit breaker check the motor,
switch, and power connection for short circuit or faulty
components
• To reset the circuit breaker:
- Press the red (0) button so that the machine is
turned off
- Press the Circuit Breaker Reset Button (12)
Fig.2
Fig.3