Blackmagic Design HyperDeck Studio Pro Manuel D'utilisation Et D'installation page 48

The server will respond with a list of all supported commands:
201 help:↵
{Help Text}↵
{Help Text}↵
↵
Switching to preview mode
The "preview" command instructs the deck to switch between preview mode and output mode:
preview: enable: {"true", "false"}↵
Playback will be stopped when the deck is switched to preview mode. Capturing will be stopped when the
deck is switched to output mode.
Controlling device playback
The "play" command instructs the deck to start playing:
play↵
The play command accepts a number of parameters which may be used together in most combinations.
By default, the deck will play all remaining clips on the timeline then stop.
The "single clip" parameter may be used to override this behaviour:
play: single clip: {"true", "false"}↵
By default, the deck will play at normal (100%) speed. An alternate speed may be specified in percentage
between -1600 and 1600:
play: speed: {% normal speed}↵
By default, the deck will stop playing when it reaches to the end of the timeline. The "loop" parameter may be
used to override this behaviour:
play: loop: {"true", "false"}↵
By default, the deck will start playing from the current position on the timeline. The "start" parameter may be
specified to override the start-point for playback:
play: start: {timecode}↵
If loop mode is set, the playback loop will be between:
the "start" position and the end of timeline for play forward,
the "start" position and the start of timeline for play backward.
By default the deck will continue playing until the end of the timeline. The "end" parameter may be used to
halt playback at the frame before the specified timecode:
play: end: {timecode}↵
If loop mode is set, the playback loop will be between:
the start of timeline and the "end" position for play forward,
the end of timeline and the "end" position for play backward.
Note that the "end" position must be:
beyond the current/or start position on timeline for play forward,
before the current/or start position on timeline for play backward.
The "duration" parameter may be used instead of the "end" parameter to halt playback after a duration
specified in timecode format:
play: duration: {timecode}↵
These three parameters are not compatible with the "single clip" parameter.
Stopping deck operation
The "stop" command instructs the deck to stop the current playback or capture:
stop↵
Informations pour les développeurs 161 161