Control Panel - HQ Power HQLB10001 Mode D'emploi

4.3 Secondary Suspension
Hanger
Where a hanger is provided, the bearing parts of the hanger shall be capable of
supporting ten (10) times the weight of the luminaire without permanent deformation
and shall be manufactured from non-combustible materials such as steel or its
equivalent.
Accessories
The design of the luminaire shall be such that removable accessories, e.g. colour frames
and barn doors, when properly inserted, cannot fall out of the luminaire.
Secondary Suspension
A secondary suspension shall be provided for the luminaire, except where the luminaire
is arranged for floor mounting or if it is intended for handheld use. The secondary
suspension shall be designed and mounted in such a way that in the event of a failure of
the primary suspension, no part of the luminaire can fall. The secondary suspension
must withstand a 30 cm vertical drop for 30 times.
4.4 Connection
Have a qualified electrician carry out the electric connection.
Connect the device to the mains with the power plug. All devices must be powered
directly off a grounded switched circuit. Do not connect to a dimmer pack.
The installation has to be approved by an expert before the device is taken into service.
5. Overview
Refer to the illustrations on page 2 of this manual.
1
2
3
4
6. Operation
The device can be used in the following modes:

stand-alone mode

master/slave

with a DMX-512 controller.
6.1

Control Panel

Access the control panel functions using the four panel buttons located around the
display.
Menu
Enter
V. 05 – 05/03/2019
power input
DMX input
display
control panel
scroll through the menu options
upwards through the menu list
downwards through the menu list
confirm a selection
HQLB10001
5
6
7
8
9
microphone
power output
DMX output
safety hook
©Velleman nv