iOnBoost
Slim by Wagan Tech
™
USING THE USB PORT
If the charge in the iOnBoost
damage to the iOnBoost
convenient.
1. Connect the USB device to the iOnBoost
2. Turn on the master switch
3. Press the Power button to activate the USB port.
4. When your mobile device is fully charged, disconnect your device from the
iOnBoost
™
LED FLASHLIGHT
If the charge in the iOnBoost is low, the light will shut off to prevent damage to
the iOnBoost. Recharge the iOnBoost as soon as convenient.
1. Turn on the master switch
2. Hold down the Power button for 3 seconds to turn on the light.
3. Short press to cycle through the lighting modes: 1=strobe, 2=S.O.S., 3=off
or long press to turn off from any mode.
4. Turn off master switch when done.
5. Recharge battery as soon as convenient.
PROPER DISPOSAL
•
This product has no consumer serviceable parts.
•
Do not attempt to remove or replace the battery used in this device. When
the battery has reached the end of its lifetime, please take the entire unit to
a battery recycling facility.
11
Slim is low, the USB port will shut off to prevent
™
Slim. Recharge the iOnBoost
™
Slim and turn off the master switch.
www.wagan.com
®
Slim as soon as
™
Slim with a USB cable.
™